Jumpzylla Fitness Installation Guide

Thank you for choosing the Jumpzylla Fitness Trampoline! Follow these step-by-step instructions to set up your rebounder safely and efficiently.

📦 Compatible with:

• 40-inch model (450 lbs capacity)
• 48-inch model (550 lbs capacity)

---

🔧 What’s Included

Refer to your product packaging for:

• Frame with pre-installed mat and bungee cords
• Legs with caps
• Handrail legs, supports, and bar with foam grip
• Secure pin, adjustment knobs, extra foot pads
• Bungee cord tool

For a full parts list by model, see page 5 of the manualJZ Installing manual 20….

---

⚠️ Before You Begin

• Assemble on a flat, clean surface
• Recommended for adults/teens (supervised if minors)
• Use proper lighting and avoid night assembly
• Keep a 6 ft clearance around the trampoline
• Ensure at least 10 ft of vertical clearance
• Only one person should jump at a time

If you feel unwell during use (dizziness, pain, etc.), stop immediately and consult a physicianJZ Installing manual 20….

---

🛠 Step-by-Step Assembly

✅ Step 1: Unfold the Frame

• Unfold the trampoline frame with the mat (A) facing down.
• Press the frame down gently until it lays flat on the groundJZ Installing manual 20….

---

✅ Step 2: Secure the Frame

• Insert the secure pin (I) through the aligned holes to lock the frame in place.

---

✅ Step 3: Check Bungee Cords

• If any cords are loose, use the bungee installation tool (L) to guide them back in.
• Ensure cords are tight and evenly spaced.

---

✅ Step 4: Attach the Legs

• Screw each leg (C) into the leg sockets firmly.
• Make sure all legs are evenly positioned for stability.

---

✅ Step 5: Add Handrail Legs

• Stand the trampoline upright.
• Attach handrail legs (D & E) to the front two legs (without leg caps).
• Use leg adjustment knobs (K) to secure (do not over-tighten yet).
• Reattach the leg caps once securedJZ Installing manual 20….

---

✅ Step 6: Assemble Handlebar

• Connect handrail supports (G & H) to the foam handlebar (F).
• Secure each side using bar adjustment knobs (J).

---

✅ Step 7: Final Assembly

• Connect the handlebar to the leg supports.
• Adjust to your desired height and tighten all K knobs.
• Ensure all legs, caps, and knobs are secure and level.

---

✅ Step 8 (Optional): Hook Cover

• Hook the 4 ropes from the mat edge into the metal buckles to keep the cover flat.
• Use extra foot pads (M) for balance if needed (not required on all legs).

---

🧪 Final Safety Check

✅ Trampoline is level and secure
✅ Handlebar is stable and fully assembled
✅ No missing or loose parts
✅ Bungee cords are fully attached
✅ Clear space around and above the trampoline

---

📞 Need Help?

If you’re missing any parts or need assistance:

📧 Email: [e-mail]
📞 Phone: [phone]
📷 Have photos ready if reporting an issue

We’re here to help you bounce safely — one jump at a time!